The computational method of estimating vibration stress levels for GTE compressor blades

At present, the process of designing a GTE involves a large amount of computational modeling. With the help of computational modeling, it is possible to predict a behavior of an engine part during engine operations before conducting experimental studies. For example, the numerical dynamic behavior analysis of compressor blades and prediction of dynamic stress levels during fluctuations in free modes are urgent problems. A high level of dynamic stress in the compressor blades in resonant modes can break a blade and stop an engine. In this paper, we propose a simple vibration stress estimation method for the compressor blades based on the calculation of natural frequencies and vibration forms. The method is based on a comparative analysis and scaling of stresses by the value of the total potential or kinetic energy. This estimation method is valid for local changes in the blade geometry, which do not lead to changes in the natural frequencies and vibration forms of the blades, assuming that the geometry change does not change the level of the aerodynamic excitation of the blade or its damping. At the stage of development or revision of the blade, a large number of variants of the blade geometry needs to be analyzed in order to reduce dynamic stresses. The proposed vibration stress estimation method has shown its high efficiency in developing and refining the geometry of the compressor blade. The vibration stress estimation method was tested using the rotor blade of a high-pressure compressor. As a result of the experimental study of the rotor blade, a high level of vibration stresses exceeding the permissible level was found for natural frequencies and vibration forms. To reduce the vibration stresses, measures were proposed to modify the geometry of the blade. For the modified blade geometry, the vibration stress estimation was performed with a prediction of the vibration stress values based on the manifested vibration forms. In order to verify the estimated vibration stress change, an experimental study of the modified blade was conducted. The vibration stress estimation method for the compressor blades was successfully verified.