Assessment of technical condition of c series power hydraulic cylinders of mounted hydraulic systems of tractors

Introduction. The existing methods of assessing the technical condition of power hydraulic cylinders do not allow one to conclude about the need to restore worn surfaces of parts. The data on limit values of wear of parts (wear and tear value at which a decision is made to repair) in technical requirements to overhaul and other technical documentation of hydraulic cylinders are not currently available. The aim of the study is to determine limit values of wear of working surfaces of hydraulic cylinder parts of C series. Materials and Methods. To assess the technical condition of hydraulic cylinders used, the authors developed a device on the basis of the stand KI-28097M-GOSNITI, equipped with an independent hydraulic station and load hydraulic cylinder, at which bench tests were carried out in the operation of С series hydraulic cylinders to determine overall efficiency values. Results. Results of bench and micrometer tests of the former hydraulic cylinders of the C series (C75/30, C90/30, C100/40) are presented. The regression model of the relationship between total efficiency of C series hydraulic cylinders (C75/30, C90/30, C100/40) and wear of working surfaces of parts was obtained. According to this regression model obtained using the method of steep ascent, limit values of wear of the working surfaces of C series hydraulic cylinder parts (C 75/30, C 90/30, C 100/40) were determined. Discussion and Conclusion. 19,5 % of hydraulic cylinders of C series (C75/30, C90/30, C 100/40) were operated in an out-of-limit condition. In case of technical service companies carrying out the input control of to-be-repaired hydraulic cylinders, limit values of wear for hydraulic cylinder surfaces, determined by the method of steep ascent, allow for making proper decisions on the need of their restoration.