Cross Layer Design and Performance Analysis of HARQ Schemes in Multi-Relay Networks
Journal: International Journal of Wireless and Microwave Technologies(IJWMT) @ijwmt
Article in issue: 5 Vol.1, 2011.
Free access
We propose a cross-layer design combining adaptive modulation and coding (AMC) at the physical layer with a hybrid automatic repeat request (HARQ) protocol at the data link layer in multi-relay networks with imperfect channel state information (CSI). Based on a simple and distributed relay selection strategy, we derive the closed-form expressions for performance metrics such as average packet loss rate (PER) and spectral efficiency; and further formulate an optimization model to maximize the spectral efficiency under the target PER constraint. The numerical results show that the average PER is lower and the spectral efficiency is higher with the number of the relay increasing.
Similar articles in the section Industries, crafts and trades for finished or assembled articles
Short address: https://sciup.org/15012767
IDS: 15012767
References Cross Layer Design and Performance Analysis of HARQ Schemes in Multi-Relay Networks
- Srivastava, V. Motani, M., "Cross-layer design:A survey and the road ahead", Communication Magazine, IEEE, vol.43, 2005, pp.112-119.
- Changchun Li, LinglingXu, Dongfeng Yuan and Feijin Shi, "Performance analysis and comparison of HARQ schemes in cross layer design", ChinaCOM, Xian, 2009, pp. 1-5
- Mahan, B., Hjorungnes, A. and Debbah, M., "Outage Probability Analysis of Multi-Relay Delay-Limited Hybrid-ARQ Channels", Vehicular Technology Conf. (VTC 2010-Fall), 2010, pp.1-5
- Shaolei Ren, Letaief,K.B. and de Marca, J.R.B., "Outage reduction in cooperative networks with limited feedback", IEEE Trans., vol.58, no.3, March 2010, pp.748-752
- John G. Proakis and Masoud Salehi. , "Digital Communications" New York, McGrawHill, 1989.
