Theoretical Design and Computational Fluid Dynamic Analysis of Projectile Intake
Автор: Wei Wang, Likun Cui, Zhuo Li
Журнал: International Journal of Intelligent Systems and Applications(IJISA) @ijisa
Статья в выпуске: 5 vol.3, 2011 года.
Бесплатный доступ
With the development of the science and technology, the more requirements such as cost effective, high specific impulse in wide operation rang, becomes stricter and multiplicity. However, the existing supersonic inlet can no longer adjust to all the new projectiles. In this paper, based on the basic characteristic of inlet and considering the design requirements, the two-dimensional supersonic projectile inlet was designed and verified by numerical simulation under different operating conditions such as attack angle, altitude, and so on. The results are shown that: 1) The design process is successful, but the working conditions should be limited to the small angle of attack; 2) The total pressure recovery coefficient is increasing as the Ma number increases, and then is gradually decreased after the point of Mach number is equal to 0.5; 3) The existence of attack angle reduces values of total pressure recovery. And moreover, the shock wave which occurs at the anterior point is gradually deviating from projectile body direction with the increase of attack angle; 4). The variance ratio in the outlet has the acute changed with increasing of altitudes clearly, but its corresponding values degrade sharply in the entrance.
Supersonic air inlet, two-dimension, ramjet projectile, numerical simulation, influence factors
Короткий адрес: https://sciup.org/15010225
IDR: 15010225
Список литературы Theoretical Design and Computational Fluid Dynamic Analysis of Projectile Intake
- D. A. Ault, D. M. Wee, “Experimental and computational results for the external flow field of a scramjet Inlet,” Journal of Propulsion and Power, vol. 4, pp. 178-193, 1994.
- P. Safaris, A. Polka, “Optimal shock wave parameters for supersonic inlets,” Journal of Propulsion and Power, vol. 12, no. 1, pp.21-25, 1996.
- W.Wang, L.K. Cui, Z.Li, “Design and study of two-dimensional supersonic projectile inlet”, SMSME2011, Wuhan: IEEE Press. 2011
- R. D. Richtmyer, K. W. Morton, Difference Methods for Initial-value problem, New York: Interscience, 1967.
- G. Chesshire, W. D. Henshaw, “Composite overlapping meshes for the solution of partial differential equations”. Journal of Computational Physics, no. 90,pp1-64,1990,
- Y.Z. Zhang, Z. Li and H. L. Li, “Three-dimensional numerical simulation of afterburner flow field of solid rocket ramjet”, Aeroengine, vol. 35, no. 3, pp.22-26, 2009 (in Chinese).
- K. Oswatisch, “Pressure recovery in missiles with reaction propulsion at high supersonic speeds”, NACA, TM1140, 1947.
- S. B. Luo, W. C. Luo, M. Ding, et al, “The multi-level and multiobjective optimization design method for two dimensional scramjet inlet”, Journal of National University of Defense Technology, vol. 26, no. 3, pp.1-6, 2004 (in Chinese).
- H.K.Versteeg, W. Malalasekera. An introduction to computational fluid dynamics: the finite volume method,1st ed. Pearson Prentice,1995
- J. D. Anderson, Computational fluid dynamics: the basics with applications, New York: McGraw-Hill companies Inc,1995
- Y. Bartosiewicz, Z. Aidoun, Y Mercadier, ”Numerical assessment of ejector operation for refrigeration applications based on CFD” ,Appl Therm Eng 2006,26(5-6):604-12
- A. Hemidia, F. Henry, J-M. Seynhzeve, Y. Bartosiewicz. “CFD analysis of a supersonic air ejector: part I: experimental validation of single-phase and two-phase operation”, Appl Therm Eng2009,29:1523-31
- X. J. Zhang, D. W. Liang, "Performance effects of geometry parameters on hypersonic inlet ,"Journal of Nanjing University of Aeronautics & Astronautics ,vol. 37, no. 6, pp.685-689, 2005 (in Chinese).
- W. Wang , Z. Li and H. L. Li, et al, “The numerical simulation of a solid ramjet engine inlet base on fluent”, Journal of Sichuan university(Engineering Science Edition) ,vol. 40, pp.83-85, 2008 (in Chinese).
- S. Y. Zhang, Y. Z. Bai, "Numerical simulation and analysis for 2-D supersonic inlet," Journal of Projectiles, Rockets, Missiles and Guidance, vol. 28, no. 3, pp.203-205+209, 2008 (in Chinese).
- X. Z. Liu, C. M. Zhang, Power plant of cruise missile, Beijing: Aerospace Press, 1992 (in Chinese).
- W. Q. Pan, Engineering fluid mechanics, Beijing: Tsinghua University Press, 1990 (in Chinese).
- M.J. Ostrander, M.E. Thomas, J.B. Clegern. “Inlet analysis for ATR-Powered Supersonic Missile”. AIAA-95-2805
- J.H. Ferziger, M. Peric. Computational Methods for Fluid Dynamics, third rev edition, New York: Springer, 2002